ravip Posted November 2, 2021 Share Posted November 2, 2021 I found this video by chance. This really works, as I already tried it out on a calculator. (I hope this is on the correct thread) Link to comment Share on other sites More sharing options...
johng Posted November 2, 2021 Share Posted November 2, 2021 I now a few years after below photo have a similar looking problem with the LCD display on my motorbike...not sure its quite so easy to remove the display from the printed circuit board though. Link to comment Share on other sites More sharing options...
OneMoreFarang Posted November 2, 2021 Share Posted November 2, 2021 5 minutes ago, johng said: ..not sure its quite so easy to remove the display from the printed circuit board though Probably it's not too difficult to remove it. But it might be difficult to get it precisely together again... ???? 1 Link to comment Share on other sites More sharing options...
johng Posted November 2, 2021 Share Posted November 2, 2021 Just now, OneMoreFarang said: difficult to get it precisely together again... ???? Ha Ha Yes that's very often the case ???? 1 Link to comment Share on other sites More sharing options...
ravip Posted November 3, 2021 Author Share Posted November 3, 2021 16 hours ago, johng said: I now a few years after below photo have a similar looking problem with the LCD display on my motorbike...not sure its quite so easy to remove the display from the printed circuit board though. Yes, on some equipment the removal and assembly may be difficult. But, if the device has come to the stage of replacement due to this issue, why not give it a try! Link to comment Share on other sites More sharing options...
johng Posted November 3, 2021 Share Posted November 3, 2021 6 minutes ago, ravip said: if the device has come to the stage of replacement due to this issue, why not give it a try! Yes I fully agree and will try when the readout becomes worse than it is..at the moment it's quite noticeable but not bad enough to make the speedo unusable..just don't fancy trying to unsolder those 2 long rows of pins. 1 Link to comment Share on other sites More sharing options...
johng Posted November 4, 2021 Share Posted November 4, 2021 Actually looking closer I'm not quite sure I have the same problem. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now