Anyone know of any shops in Thailand selling these?

O2 sensor eliminator to plug into the harness instead of the wire from the O2 Lambda probe in header

Also plug for hole in header? Although I am sure I can find something

Thanks

( I do have a note in to Dirt Shop in BKK but not heard back yet )

Here is what i did before my pcv arrived..

just two resistors if you cant find the value i will look for you.

Here is what i did before my pcv arrived..

. just two resistors if you cant find the value i will look for you.

Ah very interesting.

That is pretty much what I thought that little eliminator looked to have in it.

Ok thanks!

Will look for the values

So did you just used the plug on the existing O2 Lambda sensor / buy new or just plug the resistors right into the recieving

end of the harness? I am not sure by the pic

Thanks again

I just pushed them in the original harness added some tape and no problem.I am thinking 330 ohms.

I just pushed them in the original harness added some tape and no problem.I am thinking 330 ohms.

That sounds nice & easy just the way I like it

So you never got a CEL with your mod?

Thanks

Ok looks like 330/ half or 1 watt is the value.

This thread looks like he used only one resistor though?

http://www.600rr.net/vb/showthread.php?t=184998

also jumping what pin to which pin? I see he claims black & white wires

Will have to look if I am the same as that is a cbr600 thread.

On yours you just shunted all pins by using 2 resistors?

no fault codes.I think I looked at the pvc pic and jumped out the same way. two resistors for sure but this was on my Kawasaki

no fault codes.I think I looked at the pvc pic and jumped out the same way. two resistors for sure but this was on my Kawasaki

I am thinking after looking at the picture posted above of the plug they sell that I may be dealing with a male plug.

If so I could try & find the female counterpart or cut the one off the lambda sensor in such a way that I can reuse it

if I sell later with stock exhaust. ( leave some pigtails )

Will see how she goes when the FI controller gets here

Thanks again for the tips!