Jump to content

johng

Advanced Member
  • Posts

    16,519
  • Joined

  • Last visited

Posts posted by johng

  1. Yes there are not many films being released,  I saw  that at the Avenue they have one film in English "Ava"

     

    The cinema at  Central Festival Marina ( A.K.A  Big C north)  has only shown movies in Thai language for a long time now ( Since the cinema at Royal Garden closed )

    • Like 1
  2. 29 minutes ago, jacko45k said:

    Not sure how a fault on the supply side can cause the meter to spin....

    Yes good point

     

    18 hours ago, rocky123 said:

    After I turned off my supply from the mains box, and showed them my meter, outside , on the pole was still spinning,

    So it would seem that someone has "tapped"  into the output side of the meter and when they poked about

    it got disconnected , they should have investigated where that rogue  connection wire  lead to.

    • Like 1
    • Thanks 1
  3. 2 minutes ago, Metropolitian said:

    The mask for transfering the pcb tracees ( either way, toner transfer or UV method) was flipped

    Yes correct ???? .. the original author's gerber file was (I think) correct   but I had a "brain fart" and  flipped image before laser printing ...tried the "cold transfer" method using  nail polish remover and isopropyl alcohol  which took a couple of attempts to get  the transfer to stick , didn't realise the mistake until looking for the tiniest little drill bit I could find in my collection.

  4. 14 minutes ago, maxpower said:

    Best to dim led strips at the low voltage point using  a PWM dimmer which are available from specialist LED shops.

    Yes  Pulse Width Modulation  to dim LED's

    if  anyone is interested in a D.I.Y project  ( yes I did get it to work eventually even made my own PCB )

    https://www.instructables.com/id/Easier-WiFi-LED-Light-Strip-Controller/

     

    spot the "un-deliberate" mistake  which worked out ok as I didn't have to drill loads of holes ????

    P_20200626_152816.thumb.jpg.6416a89339429ae3a2991bb3e7cc4a08.jpg

     

    • Like 2
  5. 25 minutes ago, rocky123 said:

    I asked whether I would get a refund, and they said no, it was not their fault. I pay by standing order so they took out my bank already.

    Well from your explanation it clearly is  their fault  as the "fault" was on "their" side of the meter..getting a refund from them is another matter..but I do remember reading of some people getting refunds after the cases got some  media attention.

     

    • Like 2
×
×
  • Create New...
""