1 hour ago, Steve&mem said:

Relay's included, but the wiring is not what I thought, if I had connected to what I had show before I would have reversed the fuel and 12v- connection's. The picture of the back of the 5 pin ATS connection's we can see some of the numbers.

Red cable Pin 1, 12v pos

Yellow cable Pin 2, Crank

Orange cable Pin 3, I believe to be the start Relay

Green cable (it looks blue in the picture) Pin 4, Fuel

Black cable Pin 5, 12v neg.

 

I have now found the on-line manual for the smartgen controller and a few youtube vids as well. 

HGM6110N_6120N_6110NC_6120NC_6110CAN_6120CAN_en.pdf (smartgen.cn)

 

 

What I would do now is bring the ATS connections onto a terminal block and attempt to simulate what is required to initiate a remote start. This will prepare you for interfacing with the programmable controller.

Just an update, new toy came yesterday from China no tax to pay but the controller only cost 2954 Baht (Chinese Copy).

Manage to light it up with 12v battery so today started hacking my metal box to fit it all in, hopefully I can get it finished this weekend.

I been waylaid with this project so now back on the job, here are a few pictures of the finished product, well sort of finished. It's not a plug and play control panel, I've been tearing my hair out getting the parameters to suit my set up. Also 1 of the 5 cables from the genset  does not appear to do anything, so tomorrow's job is to pull the front panel of off the genset and see were that cable is going to, but the genset is starting and stopping in auto mode with the control panel.

Also been an amateur I managed to destroy my ATX in the breaker box by cross threading one of the terminal's 😭