Configuring D-link Dslg604t For Tue

[bangbuathong]

I'm stuck, although I have tried the suggestions in the forum Still can't get the thing to work.

these settings give ADSL 'on " status, but i cannot connect

used the following settings: VPI=0

VCI=100

dns1 203.144.255.244

dns2 203.144.255.72

is it possible at all to use this modem/router?

pls some advice

thanks in advance

[MadFrankie]

the ADSL on light just means theres a carrier signal on your line

[lopburi3]

I use primary DNS of 203.144.255.71 - not sure it what you are using is valid or not but it is not what they recommend on web site.

Do you have a network connection made up and able to sign on ok?

[bangbuathong]

ok lets start from the beginning,

modem settings as follows:

modulation : mmode (auto detects modulation type)

PPPoE

VPI = 0

VCI = 100

username and password filled in

nat enabled

firewall disabled (to avoid conflict with running software firewall)

pls show me the next steps to cinfigure internet and network connection

thanks in advance

[Mr_Happy]

Make sure it is also set for "LLC" also. I would first login into the modems web interface and insure the connection is up then work from there. Make sure DHCP is turned on the modem and your network card is set to get a IP address.

[bangbuathong]

thks for your reply

link-up and accessed interface

changed settings to gdmt

dsl status shows: connected

upstream/downstream 640/6144

lan ip 192.168.1.1

subnet 255.255.255.0

dhcp server running

but the pppoe connection still shows disconnected

do i have to change somthing at the dynamic/static routing

pls advice thks

[Richard-BKK]

Hello Bangbuathong,

I found a easy way to setup a D-link router, including with pictures.

http://adsl.yoll.net/ADSL-routers.html

Click on "ROUTER SETUP"

With kind regards,

Richard

[bangbuathong]

thank you all for the support, but had to further than the nose, on www.dlink.in.th

is a firmware upgrade specialy for thai internet, which explains the missing LLC on PPPoE

the only things needed to be set (a wizzard came with the firmware upgrade) where PPPoE, VPI and VCI rest was detected auto.

billion modem which made the os hold in the drawer just in case...

kind regards,