Specifically T profile bar, approx. 1 1/4- 1 1/2" (3-4cm) X 5/8- 3/4" (15-20mm). I've seen everything but, at 10 or so shops I've looked in. Even Global House with its big selection of steel products is mai mee. "Not sure/ don't know if they have" is not very helpful so confirmed sightings if you know of a source. Any help is appreciated, thanks.

As in below.

Never seen it here.

Good luck in your search.

If you are on the superhighway heading from the river towards Maya, turn left on to Chang Puak. There is a walk over. About 100 meters before that, before the entrance to the university, there is a steel shop. Small frontage, but actually a cavernous place. They will have it or can get it. Been buying stuff there for five years.

Another shop to try if you havnt already.

From Charoen Muang Rd, turn onto Bumruang Raj rd.

Look out on your right side, open fronted shop with metal on racks.

If you could not find what you are looking for ,you could weld

two angle iron together,would that work for you.

regards Worgeordie

If you are on the superhighway heading from the river towards Maya, turn left on to Chang Puak. There is a walk over. About 100 meters before that, before the entrance to the university, there is a steel shop. Small frontage, but actually a cavernous place. They will have it or can get it. Been buying stuff there for five years.

I was in that shop yesterday, no have, but thanks. If I can't find or order, as a last resort I can try to have 2 pcs of flat bar welded. 2 angles welded together will give too thick a 'flange'.

If you are on the superhighway heading from the river towards Maya, turn left on to Chang Puak. There is a walk over. About 100 meters before that, before the entrance to the university, there is a steel shop. Small frontage, but actually a cavernous place. They will have it or can get it. Been buying stuff there for five years.

I was in that shop yesterday, no have, but thanks. If I can't find or order, as a last resort I can try to have 2 pcs of flat bar welded. 2 angles welded together will give too thick a 'flange'.

Yes welding two flat bars would work but you would need to make a jig and stitch weld it on opposite sides to avoid it ending up like a banana.