What Male Terminals to Use?

[carlyai]

Just bought a new AVR, no power input and output terminals supplied.

What male terminals fit  this AVR?

[Crossy]

If you take that cover off, does it reveal that those are actually crimp-lugs on bolted terminals??

 

You will probably have to feed the wire through the hole before putting on the crimp.

 

[carlyai]

10 minutes ago, Crossy said:

If you take that cover off, does it reveal that those are actually crimp-lugs on bolted terminals??

 

You will probably have to feed the wire through the hole before putting on the crimp.

 

OK thanks again. Will have to wait till I get home as getting son's car fixed at Mukdahan. Bloody kids. 🙂

[bluejets]

21 hours ago, carlyai said:

What male terminals fit  this AVR?

 

Appears (in this 5kva model at least) to be run-of-the-mill terminal block.

 

Lower RHS of photo...............

 

 

[carlyai]

@bluejets Thanks very much. 

Have to investigate a bit further as seems strange (to me) if you have to take the cover off to connect the power cables. Probably has those stickers over the cover screws as well.

Hope you are going good with that other problem and if you get here to Thailand send me a PM and I'll try and pop in and say hello. 🙂

[Crossy]

Just remove the two screws on the gland plate.

What can you see inside?

 

[Fruit Trader]

41 minutes ago, Crossy said:

Just remove the two screws on the gland plate.

What can you see inside?

 

 

Its exactly what you are thinking, allows the screw terminals to be pulled out.

 

[carlyai]

I took the cover off to see the neutral strapping.

Had trouble connecting my large power cables (no trouble with the Lioa as different connectors).

All going but cables not cleaned up, have to make up some pigtails to get it neater.

[CanadaSam]

Here is the instruction manual, it is in Russian, but not difficult on my laptop to right click and translate with Google translate.

 

https://service-instruction.ru/manual/211866/daewoo-dw-tzm12kva?page=7

[bluejets]

On 8/6/2024 at 6:46 PM, carlyai said:

I took the cover off

As I suspected, basic tunnel terminals.

So either straight stripped back cable/ or use appropriate size cable ferrule.

[johng]

I wonder what happens if you actually  do "tear down this paper"  ?

as warned not to in one of the above photos.

[carlyai]

5 minutes ago, johng said:

I wonder what happens if you actually  do "tear down this paper"  ?

as warned not to in one of the above photos.

Nothing will happen, but it's a good warning not to terminate the neutral and active wires onto the wrong terminals, because then there will be a lot of excitement.