Stainless steel or PVC rain gutters

[Orangutan]

I have a short run 4 meter rain gutter that I want to install on my house. I have read that the PVC products all developed leaks at the joints, and that the stainless steel gutters need to be replaced because of rust every five years. I would appreciate any advice that can point me in the right direction.
Many thanks,

~O

 

[Will B Good]

Just had stainless fitted...certainly not expecting them to rust (or is this Thai stainless steel?)

 

PVC?......Sounds ify in this climate.

[McTavish]

I prefer the colorbond extruded on site guttering complete with leaf guard if you have trees nearby.  I have a 5m run on the pool cabana with no faults or leaks found in 4 years service.  Compared with alternates it is unobtrusive and fast to have installed.

[Orangutan]

My initial thought was to use color bond, guttering I called blue scope headquarters office in Thailand they did not answer the phone nor reply to an email that I sent them . I would prefer a color bond does anybody have a supplier/installer recommendation in the Bangkok area?

 

 

 

[NoDisplayName]

49 minutes ago, Orangutan said:

I have a short run 4 meter rain gutter that I want to install on my house. I have read that the PVC products all developed leaks at the joints, and that the stainless steel gutters need to be replaced because of rust every five years. I would appreciate any advice that can point me in the right direction.
Many thanks,

~O

 

 

4-meter section?

You're in luck.

PVC comes in.................................4-meter lengths.

Drops and ends bonded on with PVC cement, should not leak.

 

https://www.homepro.co.th/p/1164967

https://www.homepro.co.th/p/1164968

[OneMoreFarang]

Stainless steel <> stainless steel.

There are lots of different grades.

 

 

[flexomike]

1 hour ago, Will B Good said:

Just had stainless fitted...certainly not expecting them to rust (or is this Thai stainless steel?)

 

PVC?......Sounds ify in this climate.

thinking of doing some stainless gutters on my house, do you remember what the material cost is per meter, I will need about twenty meters

[bubblegum]

Have PVC for the last 8 years. No problems at all.

[Old Croc]

PVC pipe is made for plumbing jobs. It's strong, doesn't deteriorate nor rust, and won't crack or develop holes unless struck with tools or machinery. It can be painted to blend with the house.

Leaks occur because Thais don't like to use glue to seal the joints to save money and time or in case they want to move it later. 

[degrub]

PVC exposed to sunlight will gradually deteriorate due to the UV in sunlight unless specifically formulated with UV stabilizers.  You can provide similar protection by painting surfaces exposed to sunlight.

A quality latex paint should be sufficient.

[lbramy]

I'm going with stainless steel .. one piece, couple of end-caps, drop outlet. Not much room for error  - prefaced by being here for 21 years.

[Dean1953]

 

 

I had galvanized gutters installed in 2005 when my house was built. The first to go were the ones in the back of my house.  I took the second floor roof off that was over the far back end of my house and put a tiled patio in its place. I just had an awning put on top, so those gutters aren’t necessarily. After I leave to go back to the U.S. in a week, my old small entryway into the house will be torn down and a much larger entryway will be built with a large awning that will divert water coming off the front roof to mango trees planted on the side. 
The only gutters that I have left are on my garage, which work fine, and the one at the top of my house on the side, which has a large hole in the middle. I want it replaced with a stainless steel version that will outlast me at age 71. The lady that takes care of my house wants to try to have the old gutter repaired, which is BS. It’s going to be hard to find someone to work that high up, let alone trying to fix the old gutter. Any suggestions on a SS gutter would be appreciated! 

 

Edited May 20 by Dean1953
None