seedy Posted October 20, 2021 Share Posted October 20, 2021 48 minutes ago, Ralf001 said: Because the oil breaks down causing friction on the big end bearings. One seizes then the rod snaps punching the piston up into the valves ever so slightly bending the head. Then the head gasket leaks aKA is blown !! 555 Link to comment Share on other sites More sharing options...
transam Posted October 20, 2021 Share Posted October 20, 2021 49 minutes ago, Ralf001 said: Because the oil breaks down causing friction on the big end bearings. One seizes then the rod snaps punching the piston up into the valves ever so slightly bending the head. Then the head gasket leaks aKA is blown !! I think you will find the oil filter takes care of the cr_p and oil pressure takes care of the bearings.....???? So, rule of thumb is, don't leave oil filter or oil in the engine "way" past its advised life span, mileage or time frame. Ensure the engine runs in its advised temperature range. Simple steps that usually ensures no issues, unless you are unlucky and have a component failure..???? 2 Link to comment Share on other sites More sharing options...
Ralf001 Posted October 20, 2021 Share Posted October 20, 2021 10 minutes ago, transam said: I think you will find the oil filter takes care of the cr_p and oil pressure takes care of the bearings.....???? So, rule of thumb is, don't leave oil filter or oil in the engine "way" past its advised life span, mileage or time frame. Ensure the engine runs in its advised temperature range. Simple steps that usually ensures no issues, unless you are unlucky and have a component failure..???? Doubt that filter does much filtering of unburnt fuel that degrades the oil to the point it creates friction on the bearing surfaces. Link to comment Share on other sites More sharing options...
transam Posted October 20, 2021 Share Posted October 20, 2021 1 minute ago, Ralf001 said: Doubt that filter does much filtering of unburnt fuel that degrades the oil to the point it creates friction on the bearing surfaces. Anything that goes into the sump passes through the filter before it gets to the bearings. If any fuel gets into the oil it is soon dissipated, that mainly happens in old engines where the rings are stuffed. Your scenario is daft, unless you have a direct fuel leak passing into the engine bores. 1 Link to comment Share on other sites More sharing options...
tingtongfarang Posted October 20, 2021 Share Posted October 20, 2021 (edited) On 10/16/2021 at 6:21 PM, Velleman said: Ah yes ofcourse coolant too. It's an automatics yes. Will have the car serviced and the tyres checked for cracks and flat spots. I don't know if i can trust B-quik on that matter though, they'll probably recommend new tyres. stay away from b- quik their intent is to empty your wallet only, buy tires on lazada and let the local rubber smith change them, Edited October 20, 2021 by tingtongfarang 1 Link to comment Share on other sites More sharing options...
transam Posted October 20, 2021 Share Posted October 20, 2021 7 minutes ago, tingtongfarang said: stay away from b- quik their intent is to empty your wallet only, buy tires on lazada and let the local rubber smith change them, Tell me the problem you had at B-Quik...? I will pass it on...???? 1 Link to comment Share on other sites More sharing options...
seedy Posted October 20, 2021 Share Posted October 20, 2021 (edited) And yet ... The main bearings (Big End) are still in one piece !!! 170,000 Km Edited October 20, 2021 by seedy 1 Link to comment Share on other sites More sharing options...
tingtongfarang Posted October 20, 2021 Share Posted October 20, 2021 (edited) 49 minutes ago, transam said: Tell me the problem you had at B-Quik...? I will pass it on...???? First thing they will do is put your car on a lift and take the wheels off, after that they will start offering to exchange parts which are in perfect order, they changed my brake disks with non om parts and after i ended up with the front brakes on fire and locked up, this happened 3 times untill they skimmed the disks down to the original thickness, after this i just dont trust them and have heard many reports from other customers complaining , i would'nt trust them with a peddle car now Edited October 20, 2021 by tingtongfarang smelling mistakes 1 Link to comment Share on other sites More sharing options...
transam Posted October 20, 2021 Share Posted October 20, 2021 1 minute ago, tingtongfarang said: First thing they will do is put your car on a lift and take the wheels off, after that they will start offering to exchange parts which are in perfect order, they changed my brake disks with non om parts and after i ended up with the front brakes on fire and locked up, this happened 3 times untill they skimmed the disks down to the original thickness, after this i just dont trust them and have heard many reports from other customers complaining You haven't said what you went to B-Quik for...???? B-Quik use Bendix brake parts, they advertise that...???? You have heard many reports from other customers complaining...???? 1 Link to comment Share on other sites More sharing options...
tingtongfarang Posted October 20, 2021 Share Posted October 20, 2021 1 minute ago, transam said: You haven't said what you went to B-Quik for...???? B-Quik use Bendix brake parts, they advertise that...???? You have heard many reports from other customers complaining...???? i went to b-quik because my rear brake lights were on, yes i have heard reports of similar cases from other customers and non om parts 1 Link to comment Share on other sites More sharing options...
Ralf001 Posted October 20, 2021 Share Posted October 20, 2021 1 hour ago, transam said: Anything that goes into the sump passes through the filter before it gets to the bearings. If any fuel gets into the oil it is soon dissipated, that mainly happens in old engines where the rings are stuffed. Your scenario is daft, unless you have a direct fuel leak passing into the engine bores. You don't think Unburnt fuel makes it into the sump degrades the oil? Best we agree to disagree and terminate this exchange. 1 Link to comment Share on other sites More sharing options...
tingtongfarang Posted October 20, 2021 Share Posted October 20, 2021 Last time i bought tires i bought on lazada , 4 tires around 2300baht, had them fitted and balanced for 100 each 1 Link to comment Share on other sites More sharing options...
Liverpool Lou Posted October 20, 2021 Share Posted October 20, 2021 3 hours ago, Ralf001 said: Because the oil breaks down causing friction on the big end bearings. One seizes then the rod snaps punching the piston up into the valves ever so slightly bending the head. Then the head gasket leaks aKA is blown !! Yeah, right. A snapped rod can push a piston, that it's now not connected to, further up the bore than it would normally go? Do snapped rods grow in length and then re-attach themselves to the piston? Link to comment Share on other sites More sharing options...
Liverpool Lou Posted October 20, 2021 Share Posted October 20, 2021 4 hours ago, Rampant Rabbit said: the time is usually for people who do SHORT journeys where engine never gets warm and is full of condensation, Exactly the situation that the OP's car is in, then, parked for years and run for 15 minutes once a month. Link to comment Share on other sites More sharing options...
Rampant Rabbit Posted October 20, 2021 Share Posted October 20, 2021 16 minutes ago, Liverpool Lou said: Exactly the situation that the OP's car is in, then, parked for years and run for 15 minutes once a month. in a hot country where air temps already 30+c not the frozen north 1 Link to comment Share on other sites More sharing options...
Ralf001 Posted October 20, 2021 Share Posted October 20, 2021 39 minutes ago, Liverpool Lou said: Yeah, right. A snapped rod can push a piston, that it's now not connected to, further up the bore than it would normally go? Do snapped rods grow in length and then re-attach themselves to the piston? Nah , the snapped rod falls to one edge of the bore under the piston skirt and shunts it all up. 1 1 Link to comment Share on other sites More sharing options...
Kwasaki Posted October 20, 2021 Share Posted October 20, 2021 3 hours ago, transam said: I quite like this article from Haynes car manuals regarding brake fluid. ???? https://haynes.com/en-gb/tips-tutorials/how-and-when-change-your-brake-fluid I had a Volvo in UK for 22 years I never changed the the brake fluid or the auto trans fluid, maybe mileage is a factor. ???? I changed the oil and oil filter every 2 years. My Airblade scoot hasn't had it's brake fluid changed in 15 years and the dual braking system still locks up if you want it to. I changed the oil every 4 years because I go on kilos done. Had a compression test done on the Airblade recently well within spec. My experiments continue. ???? Link to comment Share on other sites More sharing options...
transam Posted October 20, 2021 Share Posted October 20, 2021 1 hour ago, tingtongfarang said: i went to b-quik because my rear brake lights were on, yes i have heard reports of similar cases from other customers and non om parts Oh, the little switch under the brake pedal needed replacing, so you had the front brake discs replaced to cure it.....???? Were all those similar cases from bar stool chat...? ???? 1 1 Link to comment Share on other sites More sharing options...
tingtongfarang Posted October 20, 2021 Share Posted October 20, 2021 12 minutes ago, transam said: Oh, the little switch under the brake pedal needed replacing, so you had the front brake discs replaced to cure it.....???? Were all those similar cases from bar stool chat...? ???? was a presure switch in the fluid system, i dont go to bars Link to comment Share on other sites More sharing options...
transam Posted October 20, 2021 Share Posted October 20, 2021 8 minutes ago, Kwasaki said: I had a Volvo in UK for 22 years I never changed the the brake fluid or the auto trans fluid, maybe mileage is a factor. ???? I changed the oil and oil filter every 2 years. My Airblade scoot hasn't had it's brake fluid changed in 15 years and the dual braking system still locks up if you want it to. I changed the oil every 4 years because I go on kilos done. Had a compression test done on the Airblade recently well within spec. My experiments continue. ???? Must confess I never changed the brake fluid in my 1988 Volvo 760 Estate until I had to replace a rear caliper, I will not tell you why I had to replace it....???? Auto trans fluid is in a virtually sealed environment, the fluid relies on temperature stability to maintain its structure, if my memory serves me well, its 175*F. If optimal temperature is maintained it can go on forever, 100,000 miles is no problem for auto fluid if temp has been in its operating window in those old boxes. ???? 1 Link to comment Share on other sites More sharing options...
transam Posted October 20, 2021 Share Posted October 20, 2021 Just now, tingtongfarang said: was a presure switch in the fluid system, i dont go to bars Brake lights are usually operated by a switch on the top end of the brake pedal, if faulty can either stay on or off. 1 Link to comment Share on other sites More sharing options...
Cake Monster Posted October 20, 2021 Share Posted October 20, 2021 On 10/18/2021 at 3:57 PM, lesmac said: Shelf life 5 years but not in high uv, production date is on them. Is it petrol or diesel and if it is petrol and had gasahol in it needs to be removed and the tank cleaned before you try starting it if you test drive to find any problems, be very aware that the seals within the Brake Calipers etc may well be perished because of Zero use Be safe ! 1 1 Link to comment Share on other sites More sharing options...
Rampant Rabbit Posted October 20, 2021 Share Posted October 20, 2021 I Like projects farms real world test, he has no vested interest unlike garages and manufacturers, nothing on his channel is sponsored by anoyne He tested lighlty used oil at 17 months age and the results were interesting 2 Link to comment Share on other sites More sharing options...
transam Posted October 20, 2021 Share Posted October 20, 2021 1 minute ago, Rampant Rabbit said: I Like projects farms real world test, he has no vested interest unlike garages and manufacturers, nothing on his channel is sponsored by anoyne He tested lighlty used oil at 17 months age and the results were interesting Yep, interesting videos... 1 Link to comment Share on other sites More sharing options...
tingtongfarang Posted October 20, 2021 Share Posted October 20, 2021 18 minutes ago, transam said: Brake lights are usually operated by a switch on the top end of the brake pedal, if faulty can either stay on or off. Nope just a presure switch on the brake line 1 Link to comment Share on other sites More sharing options...
Rampant Rabbit Posted October 20, 2021 Share Posted October 20, 2021 Just now, transam said: Yep, interesting videos... and the result, fine to use for at least another year making it 29monts old Link to comment Share on other sites More sharing options...
transam Posted October 20, 2021 Share Posted October 20, 2021 (edited) 10 minutes ago, tingtongfarang said: Nope just a presure switch on the brake line Then technology has moved on in your case. Still don't understand new rotors to cure brake lights...???? What year car/truck is it...? Edited October 20, 2021 by transam Link to comment Share on other sites More sharing options...
Kwasaki Posted October 20, 2021 Share Posted October 20, 2021 2 minutes ago, transam said: Then technology has moved on in your case. Still don't understand new rotors to cure brake lights...???? Gotta be sensor surely. All this kkrap they put in cars these days is a gravy train. Link to comment Share on other sites More sharing options...
transam Posted October 20, 2021 Share Posted October 20, 2021 Just now, Kwasaki said: Gotta be sensor surely. All this kkrap they put in cars these days is a gravy train. Be interested to know the car and year, just for my ol' grey cells... 1 Link to comment Share on other sites More sharing options...
Ralf001 Posted October 20, 2021 Share Posted October 20, 2021 36 minutes ago, transam said: Brake lights are usually operated by a switch on the top end of the brake pedal, if faulty can either stay on or off. not on modern day cars. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now