Laser Engraving

[Saraphee]

Looking for some one who can do laser work on a plaque, say brass. Or engrave and fill onto plastic or similar.

Plaque would be approx 36 x 12cms.

Any leads much appreciated!

[elektrified]

I can't help you but will say this much... quite a few years ago we had someone do some laser engraving on I think it was steel. It looked good at first but over time it "faded" - to the point of almost being invisible after about 2-3 years. So I don't think they knew what they were doing, didn't cut deep enough or something.

 

Ask to see sample of their work first! Good luck.